Help:Manual Hyphenation

Table of Contents

Hyphenation

Introduction

One of the reasons for ugly text layout is "white holes" between words, which in turn are the result of unhyphenated text. A general rule is that the shorter the a line of text, the more likely those gaps are. Hence the strong recommendation to use the hyphenator for continuous text.

Configuration

To get the best hyphenation results, you are advised to configure the hyphenator properly. This can be done via File > Document Setup > Hyphenator for the current document and File > Preferences > Hyphenator for new documents.

The dialog consists of four parts. In the upper left section (General Options) you can determine the general behavior of the hyphenator:

• Hyphenation Suggestions: If you check this option, Scribus will suggest the hyphenation for every word in a text frame. If applied to a long text, this can be time-consuming, and you may want to correct hyphenations on a case-by-case instead.
• Hyphenate Text Automatically During Typing: If checked, Scribus will automatically hyphenate text in every text frame that's being added to your document. This includes imported text.

In the upper right corner you can see the most important typographical options, namely:

• Language: There are huge differences between the hyphenation rules in different languages, so you have to make sure to select the correct one. If you use more than one language in a document, you can set up separate character styles for every language.
• Smallest word determines the length required to trigger a hyphen. The default is 3, which means that a word needs to consist at least of four characters to be hyphenated.
• Consecutive Hyphenations Allowed: determines in how many consecutive lines hyphenation is permitted. It is recommended to limit the number of lines, because otherwise the right border of a text looks like a "ladder". The default is 2, which is common in typography.

In the lower part of the dialog there are two fields that allow you to specify words that you want to be treated differently. The left field is called Exceptions. Here you can add words that aren't hyphenated correctly by the hyphenator. In the example above, the word "manuscript" has been inserted, including the desired positions for line breaks, which are specified by inserting "-" via the keyboard.

To the right there is a second field called Ignore List. Any word that has been added to this list won't be hyphenated.

Usage

Select a text frame, adjust the text alignment to your liking and then select Extras > Hyphenate Text from the menu. Note that this will only hyphenate text in a selected frame.

In the Extras menu there is also the opposite feature, called Dehyphenate Text. It is used to dehyphenate text in a selected frame, but it can also be used to dehyphenate a single word. To do the latter, you have to select a hyphenated word in a text frame and then use the menu command.

Not every possible or reasonable hyphenation can be detected by the hyphenation algorithm. In such a case you can insert a so-called "soft hyphen" into a word. "Soft hyphen" essentially tells the hyphenator: "Hyphenate here, if possible", whre "possible" means that hyphenation is not prevented by other settings, like Consecutive Hyphenations Allowed. To insert a soft hyphen, you need to place the cursor in a word at the desired break position and then use Insert > Character > Soft Hyphen.

This material may be distributed only subject to the terms and conditions set forth in the Open Publication License, v1.0 or later. Distribution of the work or derivative of the work in any standard (paper) book form is prohibited unless prior permission is obtained from the copyright holder. A copy of the license is included in the section entitled "Text of the Open Publication License."